PictureTel LIVE GATEWAY 3.1 Manuel d'utilisateur télécharger pdf (Page 41)

Fail

The Fail status indicates that the LiveGateway is not working because LiveGateway failed the POST test. To

correct the problem, refer to the POST Results described in Appendix C. The Failed status remains until you

perform another POST test, during which the Self Test status appears.

In Call

The In Call status indicates that the LiveGateway is busy and cannot send or receive more calls.

Loopback

The Loopback status is displayed when the LiveGateway is performing a loopback test.

Disabled

The Disabled status is displayed when the LiveGateway is deliberately brought out of service. To bring it back

into service, use the LiveGateway Configuration application at the server console.

Configuring the ISDN BRI

You initially configure the ISDN BRI when you install the LiveGateway software. However, you may need to

reconfigure it if your WAN switch changes.

To configure the ISDN BRI:

1. Open the LiveGateway server from the LiveGateway SNMP Manager main window.

2. Select the Gateway Boards tab of the LiveGateway Server window.

3. Perform one of the following actions:

• Click on a board in the list to highlight the board, and select Operations->

Configure... from the LiveGateway Server window's menu bar.

• Double-click the board's entry line in the list box area of the LiveGateway Server

window.

• Right-click your mouse when it is positioned over the board's entry line and

select "Configure..." from the popup menu.

4. The Configuration Gateway Board dialog box is displayed. Enter the appropriate

information in the Configuration dialog box.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 108 109

Pas de commentaire

PictureTel LIVE GATEWAY 3.1 Manuel d'utilisateur Page 41